Toro GREENSMASTER 3100 Service Manual page 95

7. Bring spring slots of both parts in line and stand parts
on end of bench. Insert spring installation tool through
spring slots of both parts. Tool is available from a Eaton
Hydraulics supplier as Eaton part no. 600057. Position
3 pairs of centering springs (or 2 sets of 3 each) on
bench so that extended edge is down and arched center
section is together. In this position, insert one end of
entire spring set into spring installation tool with spring
notches facing sleeve.
8. Compress extended end of centering spring set and
push into spool sleeve assembly withdrawing installa-
tion tool at the same time.
9. Center the spring set in the parts so that they push
down evenly and flush with the upper surface of the
spool and sleeve.
10. Install pin through spool and sleeve assembly until
pin becomes flush at both sides of sleeve.
11. Position the spool and sleeve assembly so that the
splined end of the spool enters the 14 hole end of
housing first.
IMPORTANT: Be extremely careful that the parts do
not tilt out of position while inserting. Push parts
gently into place with slight rotating action, keep pin
nearly horizontal. Bring the spool assembly entirely
within the housing bore until the parts are flush at
the meter end or 14 hole end of housing. Do not pull
the spool assembly beyond this point to prevent the
cross pin from dropping into the discharge groove
of the housing. With the spool assembly in this flush
position, check for free rotation within the housing
by turning with light finger tip force at the splined
end.
12. Place housing on clean, lint free cloth. Install 2-1/8"
diameter seal in housing.
13. Install two (2) bearing races and the needle thrust
bearing in the order shown .
®
Greensmaster 3100 Page 4 - 67
Figure 56
Figure 57
Figure 58
Repairs