Technical Information; Certificates And Approvals - Siemens SIMATIC IFP2200 Operating Instructions Manual

Technical information

7.1

Certificates and approvals

Note
Approvals on the rating plate
The following overview provides information on possible approvals.
Only the approvals on the rating plate (Page 98) of the specific device apply.
CE marking
The devices meet the general and safety-related requirements of the following EU directives
and conform to the harmonized European standards (EN) for these devices published in the
official gazettes of the European Community:
● 2014/35/EU "Electrical equipment for use within certain voltage limits" (Low-Voltage
Directive)
● 2014/30/EU "Electromagnetic Compatibility Directive" (EMC Directive)
When the device has Ex approval (see nameplate below), the following also applies:
● 2014/34/EU "Equipment and protective systems intended for use in potentially
explosive atmospheres" (Directive for Explosion Protection)
EU Declarations of Conformity
The EU Declarations of Conformity are available to the relevant authorities at the following
address:
Siemens AG
Digital Factory Division
Factory Automation
Automation Products and Systems
DF FA AS DH AMB
Postfach 1963
D-92209 Amberg, Germany
You can download information on the EC Declaration of Conformity, here under the keyword
"Declaration of Conformity":
Certificate Industrial Flat Panel
(http://support.automation.siemens.com/WW/view/en/60242448/134200).
Software license agreements
If the device is supplied with preinstalled software, you must observe the corresponding
license agreements.
Industrial Flat Panel IFP1500, IFP1900, IFP2200, IFP1900 PRO, IFP2200 PRO, IFP1900 ETH, IFP2200 ETH
Operating Instructions, 07/2016, A5E31298376-AF
7
77