Using Bypass Tray - Toshiba e-STUDIO203 Operator's Manual

2 HOW TO MAKE COPIES

Using Bypass Tray

Place paper on the bypass tray when you use the following media types as copy paper:
Thick paper (81 to 163 g/m
Special media types such as tracing paper, sticker labels or overhead transparencies
Standard size paper which cannot be placed in a drawer (e.g. A5-R)
Using the bypass tray is recommended also for copying on standard-size paper other than those
placed in the drawers. The following sizes are available for bypass copying:
Media type
Plain paper
(64 - 80 g/m
THICK PAPER 1
(81 - 105 g/m
THICK PAPER 2
(106 - 163 g/m
Tracing paper
2
(75 g/m )
Sticker labels
Transparencies
*1 "Maximum sheet capacity" refers to the maximum number of sheets when TOSHIBA-recommended
paper is used. See the following page for the TOSHIBA-recommended paper:
P.32 "Recommended paper"
*2 50 to 63 g/m
*3 Be sure to use the overhead transparencies that TOSHIBA recommends. When transparencies other
than the TOSHIBA-recommended ones are used, this could cause an equipment malfunction.
50

Using Bypass Tray

2
)
A/B format:
A3, A4, A4-R, A5-R, B4, B5, B5-R, FOLIO
2 *2
)
LT format:
LD, LG, LT, LT-R, ST-R, COMP, 13"LG
2
)
2
)
*3
A4 only
2
paper can be used if it is set on the bypass tray sheet by sheet.
Paper size
Maximum sheet
*1
capacity
2
100 sheets (64 g/m )
2
100 sheets (80 g/m )
1 sheet
2
(81 - 105 g/m )
1 sheet
2
(106 - 163 g/m )
1 sheet
1 sheet
1 sheet