Table Of Contents; Installing Your Tv Set - Toshiba 19A20 Owner's Manual

Table of Contents

Set Up
Installing Your TV Set ................................. 3
Anntenna/Cable TV Connection ................. 4
Basic Operation
Operation of Controls (TV Set) .................. 5
Operation of Controls (Remote Control) .... 6
Menu Function (General Instructions) ....... 7
Programming Channel Memory ................. 8
Convenient Remote Functions .................. 10
Setting the Off-Timer (Sleep Timer)........ 11
Adjusting the Picture ................................ 12

Installing Your TV Set

Where to install
Place the TV on the floor or on a sturdy platform.
The mounting surface should be flat and steady.
Lighting
Do not place the TV in a room where direct lighting
strikes the screen. Use soft and indirect lighting.
Air circulation
Place the TV far enough from the walls to allow
proper ventilation. This will prevent the TV from
overheating and avoid possible damage to the TV.
Avoid dusty places too.
Power supply
Plug into an electrical outlet with standard household
power (120 volt AC, 60Hz). Do not change the
plug's safety prong. See the right column.
Advanced Operation
Operating Closed Caption Feature ............ 13
Using V-CHIP Control .............................. 14
To select the V-CHIP CONTROL menu ...14
To adjust the V-CHIP CONTROL menu ...15
To temporarily unblock programs.......... 17
BLOCK CHANNEL function ............... 17
Reference Section
Cleaning and Care .................................... 18
Before Calling Service Personnel ............. 18
Limited United States Warranty .............. 19
Specifications ............................. Back cover
WARNING : TO AVOID PERSONAL INJURY
Do not stand or climb on the TV.
Do not put a VCR or any heavy object on top of
the TV.
CAUTION :
As a safety feature, the plug has one prong wider
than the other. It will fit only one way into a standard
electrical outlet. If the plug will not fit into the
outlet, try turning it around. If the plug will not fit
either way, the outlet is probably old and non-stand-
ard.
You will need to have a new outlet installed by an
electrician.
DO NOT CHANGE THE SAFETY FEATURE OF
THE PLUG.
Wide prong
3