Advertisement
4.3.
Assembling the Roof
4.3.1. Assemble the roof by connecting the parts as they are laid out in fig.1, see also fig.3.
4.3.2. There is a spring button on both ends of part 5. Make sure the button pops up when it is connected to parts 7 and 8. See fig.3.
4.3.3.
Use a wooden or rubber mallet to make sure all pipes are fully inserted.
fig.3
4.4.
Attaching the legs
4.4.1. There are 10 legs for the whole shelter.
4.4.2. Follow fig.4 drawing E1 to connect tube 1, 3 and 13 to get the 4 corner legs.
4.4.3. Then connect tubes 1 and 2 to build the 6 centre legs.
4.4.4. Insert the centre legs into the foot plates 16. Align the holes in the poles with the foot plate, push the pin bolt (part 19) through all the
holes. Insert the cotter pin (part 20) and split the tongues of the cotter pin with a slot screwdriver to secure this connection. See fig.4
drawings E2, E3 and E4.
4.4.5. Insert the prepared centre legs and corner legs into the side connectors, see fig.4 drawing E5.
4.4.6. Repeat to assemble the other side as shown in fig.5.
fig.4
© Jack Sealey Limited
Original Language Version
CPS01 Issue: 1 - 19/12/14
Advertisement
