Sealey CPS01 Instructions Manual page 5

fig.5
4.5. Assemble Bottom Cross Rails
4.5.1. Install the bottom cross rails (part 6) between each pair of legs, with cover rail clamps (parts 12 and 14) using fittings 21, 22 and 23.
Part 12 is for the centre legs and 14 is for the corner legs, see fig.6.
fig.6
4.6. Square and Anchor the Frames
4.6.1. Check the dimensions of the frame. It should be 3m between the front legs, the back legs and across the centre, see fig.7.
4.6.2. Take a diagonal measurement as shown in fig.7. When the two diagonals are equal, the frame is square. Adjust the frame until it is equal
to within 30mm. Once this is achieved recheck by repeating step 4.6.1.
4.6.3. Install anchors (parts 15, 17 and 18) at the 4 corner bent legs, by screwing the removeable anchor (part 15) into the ground inside the
shelter. Secure with cord (part 18) and clamp (part 17) as shown in fig.8.
fig.7
© Jack Sealey Limited
Original Language Version
fig.8
CPS01 Issue: 1 - 19/12/14