Cleaning The Appliance; Troubleshooting - Silvercrest SHAZ 22.2 B2 Operating Instructions Manual

♦ To replace the floor brush 0 after cleaning, proceed as follows:
–
Push the release button 9 back outwards .
Start by pushing one end of the floor brush 0 onto the drive shaft on
the opposite side of the switch 9 . Note that only one side of floor
brush 0 fits onto the drive shaft .
–
Now push the other end of the floor brush 0 into the appropriate
recess under the release switch 9 and then release this .
♦ Ensure that the floor brush 0 is fitted correctly before using the floor
nozzle 8 again .

Cleaning the appliance

♦ Clean the housing and the attachments with a slightly damp cloth .
For stubborn soiling use a mild detergent on the cloth .
♦ Dry all parts thoroughly before using the appliance again or storing it .

Troubleshooting

Problem
The appliance is
not working .
The suction is
weak .
Dust is escaping
from the appli-
ance .
SHAZ 22.2 B2
Cause
The battery is empty .
The appliance is
defective .
The battery is almost
flat .
The suction opening
is blocked .
The filters w/i are
too dirty .
The dirt container t
is not fitted properly .
The solution
Charge the appliance .
Contact the Customer Service
department .
Charge the appliance .
Remove the blockage .
Clean the filters w/i .
Check whether the dirt container t
is correctly fitted or the lid e is
correctly closed .
GB │ IE │ NI │ 13 ■