Chapter 5: Setting Up Your Tv; Initial Setup; Selecting The Menu Language; Configuring The Antenna Input Source For The Ant/Cableterminal - Toshiba 19SL410U Owner's Manual

Initial Setup
When you first rum on or reset the TV, the Initial
Setup window will appear.
1
In the Menu Language field,
press _ or _ to
select your preferred lan_lage.
2 Press • or • to select Time Zone Setup and set
your desired time zone with _ or _ and press
0
3 Next, the Location setting window will appear.
For normal home use, press @ to select Home.
4 Next, ANT/CABLE in setup window will appear.
Press _ or _ to select the input source (Cable or
Antenna) for the ANT/CABLE input on the TV.
5
If you select
Antenna, the Channel Tuning Mode
setup window will appear. To tune only digital
channels, select Digital. To rune digital channels
preferentially over analog when entering channel
number directly, select Auto. For normal tuning,
select Standard. Press @ to continue to Auto
Tuning.
6 Press @ to select Start Scan and continue with
the Auto Tuning.
You can stop the Initial Setup with E_T. However if
you do not finish the entire Initial Setup process, the
Initial Setup window will appear every time you turn
on the TV.
Selecting the menu language
You can choose from three different lan_mges
(English, French, and Spanish) for the on-screen
display of menus and messages.
To select the menu language:
1
Press u_u and open the
Preferences
menu,
highlight Menu Language.
2
Press _ or _ to select your preferred menu
lan_mge.
24
3
Press E_T to close the Preferences menu.
Configuring the antenna input
source for the ANT/CABLEterminal
To configure the ANT/CABLE input source:
1
Press M_u and open the Setup menu.
2
Highlight
Installation
and press _.
3
(A new set of Installation menu icons will appear,
as shown below.) Open the Terrestrial menu,
highlight Input Configuration, and press @.
4
Highlight ANT/CABLE In and press _ or I_ to
select the input source (Cable or Antenna) for the
ANT/CABLE input on the TV.
5 To save your new settings,
highlight
Doge
and
press @. To revert to your original settings,
highlight Cancel and press @.
Programming channels into the
TV's channel memory
When you press _ or [_] on the remote control or
TV control panel, your TV will stop only on the
channels you pro_ammed into the TV's channel
memory.
Follow the steps below to program channels into the
TV's channel memory.