Advertisement
11. Insert a cable tie through each of the 2 holes in the
beacon bracket
(Figure
1. Holes
12. On the main control panel at the rear of the control
pad, remove and discard the blanking plug.
13. Pull out the switch connector containing
orange-red/orange and black wires and plug in the
switch.
14. Press the switch into the cutout until it clicks into place
(Figure
8).
1.
Switch
Completing the Installation
1. Install the bulkhead.
2. Apply the serial label adjacent to the machine serial
label.
3. Install the positive (red) battery cable to the positive
(+) battery terminal.
7), and secure the cable.
Figure 7
Figure 8
4. Install the negative (black) ground cable to the negative
(-) battery terminal.
5. Lower and latch the engine cover.
Operation
Using the Beacon
To turn on the beacon, press the bottom of the switch.
To shut off the beacon, press the top of the switch.
Note: The ignition switch must be in position 1 for the
beacon to work.
Maintenance
Replacing the Fuse
The beacon fuse is located in the main fuse box of the
machine. It is a 10 A fuse located in the third position from
the right
(Figure
9).
To replace the fuse, remove it by simply pulling it out from
the fuse block, and install a new fuse.
Important: Always use a fuse of the same type and
amperage as the one you are replacing; otherwise, you
could damage the electrical system.
1. Fuse block
2. Cover
3
Figure 9
3. Fuse
Advertisement
