Sealey BSL102 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR
PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.

SAFETY INSTRUCTIONS

1.1 GENERAL SAFETY
Carefully read these operating and safety instructions before use.
3
Keep them for future reference.
Keep the work area clean, uncluttered and ensure there is
3
adequate lighting.
Maintain correct balance and footing. Ensure the floor is not
3
slippery and wear non-slip shoes.
Remove ill fitting clothing. Remove ties, watches, rings, and other
3
loose jewellery, and contain and/or tie back long hair.
Keep children and unauthorised persons away from the working
3
area.
DO NOT use the clamp tool for any purpose other than that for
7
which it is designed.
DO NOT operate the clamp tool when you are tired or under the
7
influence of alcohol, drugs or intoxicating medication.
WARNING! Ensure Health & Safety, local authority, and general
p
workshop practice regulations are adhered to when using this
equipment.
1.2 MECHANICAL SAFETY
Maintain the clamp tool in good condition.
3
DO NOT operate the clamp tool if any parts are damaged or
7
missing as this may cause failure and/or personal injury.
1.3 OPERATIONAL SAFETY
When working with the clamp tool you are advised to use
3
protective equipment including safety shoes, work gloves and
safety goggles.
Never insert fingers into the tool.
3
2. SPECIFICATION & CONTENTS
SPECIFICATION.
Banding is 430BA Stainless Steel, 5.5mm wide and 0.4mm thick.
Tensile strength of banding: . . . . . . . . .480N/mm
Stainless Steel Band Cassette: . . . . . .183ft. (56 mtr)
Seals: . . . . . . . . . . . . . . . . . . . .x150
Pliers: . . . . . . . . . . . . . . . . . . . . . .x1
Dispenser: . . . . . . . . . . . . . . . . . . . .x1
2
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
I N S T R U C T I O N S F O R :
CV JOINT BOOT CLAMP KIT
BSL102
MODEL NO.
3. OPERATION
3.1. The four positions of the pliers are as follows.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
01284 757500
01284 703534
Position 1
Position 2
Position 3
Position 4
www.sealey.co.uk
Web
sales@sealey.co.uk
email
BSL102 - 1 - 281004