Advertisement
When not in use switch grinder off, remove plug from power supply.
9
warning! The grinding process can produce streams of sparks which are a potential source of ignition.
‰
dO nOt use the grinder where there are flammable liquids, solids or gases.
8
dO nOt allow grinder sparks to make contact with the operator's clothing or any other fabric such as cleaning rags. Fabrics
8
contaminated with flammable materials such as petrol, oil, grease, paint and solvents are a particular fire hazard.
To reduce the risk of clothing catching fire the operator should wear wool or cotton outer garments treated with a fire retardant in
9
preference to man-made fibres.
2. intrOductiOn
Induction motor suitable for general use. Fitted with stone guard, eye shield and spark arrestor. Includes water tray for cooling hot materials.
Features built in wheel dresser for cleaning, sharpening and truing grinding wheel surfaces. The belt sander is fitted at an angle of 45°. The
sanding belt can be easily adjusted by the quick release tracking system. Pivoting work light for added visibility.
3. speciFicatiOn
model no: ............................................................... BG150BS
motor: ........................................................................... 250W
Input: ............................................................................. 230V
Belt Size: ...................................................... 50mm x 686mm
Belt Speed: ......................................................... 895mtr/min
Stone Size: ................................................................ 150mm
Stone Speed: .......................................................... 2850rpm
Table Tilt: ...........................................................................45°
Weight: .......................................................................... 10kg
4. assemblY & installatiOn
fig.1
4.1.
Unpack the product and check contents. If there are any damaged or missing parts contact your supplier immediately.
warning! before assembly check to ensure grinder is unplugged from mains.
‰
4.2.
eYeshield
4.2.1.
Adjust eyeshield so that the perspex shield provides maximum protection against debris being thrown from the wheel.
4.3.
tOOl rest
4.3.1.
Tool rest should be adjusted to provide no more than a 2mm gap between the wheel and rest.
4.3.2.
Turn wheel by hand to check that this distance remains true for the complete rotation.
sparK arrestOr
4.4.
4.4.1.
Adjust spark arrestor to ensure that the lower edge is no more than 2mm from the surface of the wheel.
4.5.
wheel dressing tOOl
4.5.1.
Wheel dressing tool is removed by pulling from motor casing and placing on the tool rest. The rotating toothed wheels should be
placed in gentle contact with the grinding face of the wheel.
WARNING: Wheel dressing should only be carried out by a suitably trained and qualified person.
‰
4.6.
belt sander
4.6.1.
Tool rest should be be adjusted to provide no more than 2mm gap between the belt and rest.
4.6.2.
With the machine isolated from the mains, operate the belt by hand. If the belt runs out of true alter the tracking by adjusting the
tracking screw. If the belt runs off to the right, turn the tracking screw in a clockwise direction and vice versa.
4.7.
installatiOn
4.7.1.
Bolt the grinder securely to a fireproof workbench, capable of carrying the grinder's weight, using the base securing slots as a template.
Check that all assembly nuts and bolts are secure then read section 5 (grinding stones) before use.
4.7.2.
If the machine requires connecting to an extraction system, an extraction port is provided at the rear of the belt guard. A conical adaptor
may be needed if the hose is not of the same diameter as the port.
© Jack Sealey limited
Original Language Version
BG150BS | Issue:2 (H,F) 10/07/18
Advertisement
