Repositioning The Counter Weights - Toro Greensmaster 3150 Series Operator's Manual

1. Hoop link
•
For the Greensmaster 3250-D traction units, install
the offset link supplied with the traction unit.
Install the offset link
cutting unit with 2 bolts. Torque the bolts to 34 to
40 N∙m (25 to 30 ft-lb).
Important:
Position the lift hook offset toward
the front of the cutting unit.
1. Offset lift hook
•
Optionally for the Greensmaster 3250-D traction
units, you can install the chain Link and mounting
bracket available from your authorized Toro
distributor.
Figure 5
(Figure 6) to the top of the
Figure 6
Install the chain link
cutting unit with the mounting bracket and 2 bolts.
Torque the bolts to 34 to 40 N∙m (25 to 30 ft-lb).
Note:
When mounting the cutting unit to the
traction unit, hook the wider end of the chain link
to the lift arm.
g020064
1. Chain link
Repositioning the Counter
Weights
The cutting units are shipped with the counter weight
mounted to the left end and the motor mount to the
right end of the cutting unit. To change the cutting unit
to different positions, proceed as follows:
Important:
Whenever you need to tip the cutting
unit on its side, ensure that you prop it up to avoid
damaging the bedbar-adjusting bolts; refer to
Supporting the Cutting Unit (page 9)
1. Remove the 2 bolts securing the counter weight
to the left end of the cutting unit. Remove the
counter weight
2. Remove the 2 Allen head bolts securing the
motor mount to the left end of the cutting unit.
Remove the motor mount
3. Apply grease to the inside diameter of the drive
spline (Figure
4. On the left end of the cutting unit, apply a light
coating of oil to the O-ring and install the motor
mount with the 2 Allen head bolts previously
g020065
removed
20 N∙m (12 to 15 ft-lb).
6
(Figure 7) to the top of the
Figure 7
2. Mounting bracket
(Figure 9).
(Figure
8).
(Figure 8). Torque the bolts to 16 to
g011932
8).