Adjusting The Height Of Cut - Toro Greensmaster 3150 Series Operator's Manual

Adjusting the Height of Cut

Use the following chart to determine which bedknife is
best suited for the desired height of cut.
Bedknife Part No.
Edgemax 115-1880
Micro-cut
(Standard)
Edgemax 115-1881
Tournament
(Optional)
Micro-cut 93-4262
(Optional)
Tournament 93-4263
(Optional)
Extended 108-4303
Micro-cut
(Optional)
Extended 108-4302
Tournament
(Optional)
Low-cut 93-4264
(Optional)
High-cut 94-6392
(Optional)
Fairway 63-8600
(Optional)
Fairway 112–7475
EdgeMax
(optional)
Note:
For heights of cut greater than 9.5 mm (0.375
inch), install the high-height-of-cut kit.
Adjusting the Height-of-Cut Gauge
Before adjusting the height of cut, set the height-of-cut
gauge as follows:
1. Loosen the nut on the gauge bar and set the
adjusting bolt to the desired height of cut
17).
Note:
The distance between the bottom of the
bolt head and the face of bar is the height of cut.
Height-of-Cut
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
4.7 to 25.4 mm (0.188 to
1.00 inch)
7.9 to 25.4 mm (0.312 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
(Figure
12
Figure 17
1. Gauge bar
2. Height-adjusting bolt
2. Tighten the nut.
Adjusting the Height of Cut
1. Loosen the locknuts securing the height-of-cut
arms to the cutting-unit side plates
Figure 18
1. Height-of-cut arm
2. Locknut
2. Hook the bolt head of the height-of-cut gauge
onto the right side of the cutting edge of the
bedknife and rest the rear end of the bar onto
the rear of the roller
3. Nut
(Figure 18).
3. Adjusting bolt
(Figure 19).
g000489
g020074