Table of Contents
Advertisement
4
Installing the
Turf-Compensation Spring
Parts needed for this procedure:
1
Turf-compensation assembly
1
Long bolt
2
Carriage bolt
3
Flange locknut
1
Flange nut
Procedure
Install the turf compensation spring assembly on the same
side as the reel motor
(Figure 5
1. Long bolt
2. Compensation spring
assembly
3. Carriage bolts
and
Figure
8).
Figure 8
4. Flange locknuts
5. Flange nut
5
Adjusting the Blade Depth
No Parts Required
Procedure
Note: The maximum recommended blade penetration depth
is 6 mm (1/4 inch).
1. Place the verticutter reel on a level surface.
2. Place 2 gauge bars, which have the desired depth of
blade penetration below the ground, under the front
and rear rollers of the verticutter reel (on each end of
the reel)
(Figure
1. Gauge bar
Note: The verticutter blades must not touch the
g196548
gauge bars.
3. Turn the adjusting bolt on each height-of-cut bracket
(Figure
9) so that the reel blades come in contact with
the level surface on both ends.
Note: As the verticutter blades wear, the diameter of
the reel will decrease and the depth setting will change.
Check the depth setting periodically to ensure that the
desired setting is achieved.
7
9).
Figure 9
2. Adjusting bolt
g195549
Advertisement
Table of Contents
