Table of Contents
Advertisement
1
1. Snapper pin
Note: Fixed steering is recommended when cutting
side hills.
11
Adjusting the
Turf-Compensation Settings
No Parts Required
Procedure
Important: Make the spring adjustments with the
cutting unit mounted to the traction unit, pointing
straight ahead and lowered to the shop floor.
1. Make sure that the hairpin cotter is installed in the rear
hole in the spring rod
G015977
Figure 14
(Figure
15).
g015977
1. Hairpin cotter
2. Spring rod
2. Tighten the hex nuts on the front end of the spring rod
until the compressed length of the spring is 15.9 cm
(6.25 inches)
Note: When operating the machine on rough terrain,
decrease the spring length by 12.7 mm (1/2 inch).
Note: The turf-compensation setting will need to be
reset if the verticutter blade depth setting is changed.
10
Figure 15
3. Turf-compensation spring
4. Hex nuts
(Figure
15).
g196971
Advertisement
Table of Contents
