Blanking
This setting enables you to blank out the contents of the designated area. You can
designate the area using the edit pen or the numeric keys on the inch entry pop-up
screen.
IMPORTANT
The Blanking mode cannot be used with the Multi-Page Enlargement, Book 2-Sided,
Two-page Separation, Image Combination, Booklet, Transparency Interleaving, Image
Repeat, or Tab Paper mode.
Using the Edit Pen
You can use the edit pen to designate two different types of areas: a rectangular
area (two points) and a polygonal area (four points or more).
IMPORTANT
•
You can designate only one polygonal area at a time.
•
You cannot designate a rectangular area and a polygonal area at the same time.
•
You can only designate areas when the original is placed on the platen glass.
1
Place your original on the platen glass © press [Special
Features].
If necessary, see the screen shot in step 1 of "Inverting Images (Nega/Posi)," on
p. 6-4.
2
Press [M] or [L] until [Area Designation] appears © press
[Area Designation].
If necessary, see the screen shot in step 2 of "Using the Edit Pen," on p. 6-21.
3
Press [Pen Entry].
If necessary, see the screen shot in step 3 of "Using the Edit Pen," on p. 6-21.
Area Designation
6-33
6