Toro 23511 Operator's Manual page 10

Throttle Lever
Move the control forward to increase the engine speed
and rearward to decrease speed; refer to
1. Throttle lever
Operator-Presence Bail
The operator-presence bail allows the machine to
start and run.
•
To start the machine, hold down the
operator-presence bail
hold down the operator-presence bail to allow the
machine to run.
1. Operator-presence bail
•
To stop the cutting blades, release the
operator-presence bail.
Figure
Figure 6
(Figure 7). Continue to
Figure 7
Depth-Control Lever
The depth-control lever allows you to set the depth of
6. the cutting blades in 10 cutting positions along with
1 position for transportation. To adjust the depth,
remove the hairpin cotter, pull the locking pin out, and
move the lever forward or rearward to the desired
depth setting
Important:
Do not pull the lever side to side as
this will bend it.
g241996
1. Depth-control lever
2. Transport-position hole
g241994
10
(Figure 8).
Figure 8
3. Hairpin cotter
4. Locking pin
g019441