Prior To Operation; Maintenance - DeWalt D26676 Original Instructions Manual

EN GL I SH
SHARPENING CUTTERS (FIG. 6)
1. Fasten the cutter to sharpening holder (v).
Be sure both cutter edges face in the same
direction.
2. Place the cutter edges so that they rest flat on
the grinding stone (not included).
3. Firmly grip the sharpening holder and move
back and forward to sharpen the cutter (o).
TO REINSTALL CUTTER (FIG. 5)
1. Cautiously remove the adjusted cutter/guide
bar assembly [two screws (t), guide bar (s) and
cutter (o)] from the gauge plate (r) and place the
heel of the guide bar (s) into the groove in the
drum (u).
2. Set the drum cover (q) over the adjusted cutter/
guide bar assembly and securely tighten the
three screws (m) to the drum.
3. Repeat procedure for the other cutter.
OPERATION
Instructions for Use
WARNING:
and applicable regulations.

Prior to Operation

Proper Hand Position (fig. 1)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the
main handle and the other hand on planing depth
adjustment knob (d).
Switching On and Off (fig. 1)
1. To run the tool, press the on/off switch (a). For
continuous operation, press the lock-on button
and release the on/off switch.
8
2. To stop the tool, release the on/off switch. To
stop the tool in continuous operation, press
the on/off switch once more. Always switch
off the tool when work is finished and before
unplugging.
Switching On and Off (Safety Switch)
(fig. 1)
WARNING: Do not switch the tool ON
or OFF when under load.
If your planer is equipped with a safety switch to
prevent inadvertent operation, please follow the
below instruction.
1. To run the tool, press the lock-off button (b)
and subsequently press the on/off switch (a).
Release the lock-off button (b).
2. To stop the tool, release the on/off switch (a).
Always switch off the tool when work is finished
and before unplugging.
Planing (fig. 1)
WARNING:
The feed speed should not be too
high, especially when using the
maximum depth of cut and planing
width.
are better than one deep cut.
CAUTION: Do not lock the trigger
switch on and engage the kickstand.
The vibration of the running motor will
cause the planer to move, possibly
falling from the work piece.
1. Switch the tool ON as described.
2. Slowly move the planer over the workpiece.
3. Switch the tool OFF.
Your planer is equipped with a kickstand (k). After
switching OFF the tool can be put down without
waiting for the cutters to come to a standstill

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-ups