Adjusting The Quick Shoot Control - Toro Power Clear 721 Operator's Manual

Figure 31
1. Drive-belt cover
2. Bolt (3)
3. Rotor-pulley bolt
4. Curved washer
5. Rotor pulley
2. Unhook the brake spring from the idler arm to
release the belt tension
3. Remove the screw and curved washer that
holds the rotor pulley
4. Remove the rotor pulley and the drive belt
(Figure 31).
5. Install the new drive belt, routing it as shown in
Figure 32.
Figure 32
1. Brake spring (install on
idler arm here)
2. Idler pulley
Note:
Route the new drive belt first around the
engine pulley, then the idler pulley, and finally
around the loose rotor pulley positioned just
above the rotor shaft
6. Install the rotor pulley onto the rotor shaft
31).
7. Install the curved washer and the rotor-pulley
bolt and tighten them securely
6. Drive belt
7. Rotor shaft
8. Brake spring (unhook from
idler arm here)
9. Idler pulley
10. Engine pulley
(Figure 31).
(Figure 31).
3. Engine pulley
4. Rotor pulley
(Figure 31).
(Figure
(Figure 31).
Note:
The concave side of the curved washer
goes against the outside of the pulley.
8. Install the brake spring onto the idler arm
32).
9. Install the drive-belt cover with the bolts that you
removed in step 1.
Note:
Ensure that the drive belt is properly
adjusted and operating; refer to
Control Cable (page 16)
Control Cable (page
Adjusting the Quick Shoot
Control
g008238
Model 38756
If there is more than 13 mm (1/2 inch) of slack in the
Quick Shoot cable
does not rotate left and right in equal angles, adjust
the Quick Shoot control cables.
1. 13 mm (1/2 inch) maximum slack
1. Loosen the 2 Quick Shoot control-cable clamps
(Figure 34).
g008317
1. Cable clamps
20
Checking the
and Adjusting the
17).
(Figure 33) or the discharge chute
Figure 33
Figure 34
(Figure
g006514
g286559