Advertisement
5
Completing the Installation
No Parts Required
Procedure
1.
Connect the T-handle connector to the main
power supply connector
Figure 12
1. T-handle connector
2.
Use Toro DIAG to update the software to
the latest available; refer to your Toro DIAG
Operator's Manual.
Important:
When prompted by Toro DIAG
for model and serial number, do not use the
model and serial number information from
the machine frame, use the information from
the decal located on the battery platform
(Figure
13).
(Figure
12).
g259735
2. Main power supply
connector on the battery
platform
1. Battery model number and serial number location.
3.
Turn the key to the R
machine and test the operation; if there are any
issues check the wire harness connections.
Important:
The LED display should turn on
and there should be no error messages or
flashing lights.
Note:
You do not need to turn and hold the key
in the S
position, turning the key to R
TART
turns the machine on.
4.
Install the console cover using the 4 screws
removed previously.
5.
Charge the machine; refer to your charger
Operator's Manual.
Important:
Ensure that you use the new,
correct charger per the charger Operator's
Manual; do not use the old charger with the
new battery.
Note:
The battery is shipped with a partial
charge (approximately 30%); this is enough
charge for you to perform software installation,
function checks on machine, and move it as
needed to complete setup.
7
Figure 13
position to start the
UN
g279150
UN
Advertisement
