Table of Contents
Advertisement
Default Configuration
A version of the Dell Networking OS is pre-loaded onto the chassis, however
the system is not configured when you power up for the first time (except for the
default host name, which is Dell). You must configure the system using the
CLI.
Configure Layer 2 (Data Link) Mode
To enable Layer 2 data transmissions through an individual interface, use the
switchport command in INTERFACE mode. You cannot configure switching or
Layer 2 protocols such as the spanning tree protocol (STP) on an interface
unless the interface has been set to Layer 2 mode.
Step Task
Enable the interface.
1
Place the interface in
2
Layer 2 (switching)
mode.
To view the interfaces in Layer 2 mode, use the show interfaces switchport
command in EXEC mode.
Configure a Host Name
The host name appears in the prompt. The default host name is Dell.
•
Host names must start with a letter and end with a letter or digit.
•
Characters within the string can be letters, digits, and hyphens.
Task
Create a new host name.
22
Installing the Software
Command Syntax
no shutdown
switchport
Command Syntax
hostname name
Command Mode
INTERFACE
INTERFACE
Command Mode
CONFIGURATION
Advertisement
Table of Contents
