Advertisement
2-3. Install the Rear panel onto the Display Unit
Step 6: Insert the flat cable attached to the interface unit
of one of the Rear panels into the connector
(CN901) of the Display unit which was removed
in Step 2 ⑨. (The flat cable has been pre-
inserted in the connector (CN2) of the rear panel
at the time of shipping.)
Step 7: Similarly, insert the flat cable attached to the
interface unit of the other Rear panel into the
connector (CN901) of the Display unit included
with the KRK-13.⑨.
Note: The terminal side of the flat cable must face down
towards the PCB when inserting the flat cable into the
connector.
Step 8: Fit the four tabs of the rear panel into each
Display Unit ⑩.
2-4. Connect the Dual Mobile Head Adapter to the Rear panel with the cable
Step 9: Insert one 14-pin connector of the Trunk cable (labeled with a sticker) into the
connector (J1 Primary) of the interface unit of the Dual Mobile Head Adapter ⑪.
Note: Insert the connector that has a sticker on the Trunk cable into the connector of the Dual
Mobile Head Adapter.
Step10: Secure the cable bush on the Dual Mobile Head Adapter and fit the waterproof
covering (orange) ⑫ securely over top.
Step11: Install the Molding cover ⑬ over the connector on the Dual Mobile Head Adapter
and secure it with two screws ⑭.
Step12: Insert the other 14-pin connector of the cable into the connector of the interface unit
of the Rear panel ⑮.
Step13: Secure the cable bush on the Rear panel and fit the waterproof covering (orange)
⑯ securely over top.
Note: A Trunk cable may be connected from the left side or from the right side. However the 14-pin
connector must be inserted in the proper direction.
Step14: Install the Molding cover ⑰ over the connector on the Rear panel and secure it
with two screws ⑱.
Step15: Insert one 14-pin connector of the Trunk cable into the connector (J2 secondary) of
the interface unit of the Dual Mobile Head Adapter ⑲.
Note: Insert the connector that has a sticker on the Trunk cable into the connector of the Dual
Mobile Head Adapter.
Step16: Secure the cable bush on the Dual Mobile Head Adapter and fit the waterproof
covering (orange) ⑳ securely over top.
Step17: Install the Molding cover ㉑ over the connector on the Dual Mobile Head Adapter
and secure it with two screws㉒.
Step18: Insert the other 14-pin connector of the Trunk cable into the connector of the
interface unit of the Rear panel ㉓.
Step19: Secure the cable bush on the Rear panel and fit the waterproof covering (orange)
㉔ securely over top.
Note: A Trunk cable may be connected from the left side or from the right side. However the 14-pin
connector must be inserted in the proper direction.
Step20: Install the Molding cover ㉕ over the connector on the Rear panel and secure it
with two screws ㉖.
Fig. 2-3
3
Advertisement
