Kenwood TS-890S In-Depth Manual page 73

■ Controlling the TS‑890S from a Remotely‑placed PC
● System configurations that are configured by using the ARCP‑890 and TS‑890S
Signal Type
Software
Control
ARCP-890
signal
ARCP-890 and
Audio signal Windows sound
Note:
◆ Configure "On (Internet)" in "KNS Operation (LAN Connector)" of the TS-890S.
● System configurations that are configured by using the ARCP‑890, ARHP‑890, and TS‑
890S (for the KNS connection via LAN)
Signal Type
Control signal
ARCP-890 and
Audio signal Windows sound
Note:
◆ Configure "On (Internet)" in "KNS Operation (LAN Connector)" of the TS-890S.
● System configurations that are configured by using the ARCP‑890, ARHP‑890, ARVP‑10,
and TS‑890S (for the KNS connection via Internet)
Remote Station (Remote PC)
Signal Type
Software
Control ARCP-890
signal
Audio signal ARVP-10R or
general VoIP
software
Note:
◆ Configure "On (Internet)" in "KNS Operation (LAN Connector)" of the TS-890S.
◆ When the ARHP-890 and TS-890S are connected by a USB-B connector or COM connector, the bandscope screen
refreshes at a slower speed.
◆ Even when the USB‑B connector is used for audio signal I/O on the host station side, the ARUA-10 is not used
PC
Hardware
Microphone and
speaker connected
driver to a PC
PC
Software Hardware
ARCP-890
Microphone and
speaker connected
driver to a PC
Hardware
-
Microphone and
speaker connected
to a PC
Connection
Method
-
Network
Connection
Method
-
Network
Connection
Method
Network
Software 09
Host Station(TS‑890S)
Software
-
Host Station(PC placed on the
TS‑890S side)
Software
Connect to the LAN
ARHP-890
Host Station(PC placed on the TS‑890S
side)
Software
ARHP-890 Connect to the LAN
connector, USB‑B
connector, or COM
ARVP-10H or Connect to the ACC 2
general VoIP connector or USB‑B
software
Hardware
Connect to the
LAN connector.
Hardware
connector.
Hardware
connector.
connector.
69