Advertisement
Mechanical / Electrical Specifications
Electrical Specification
Model
Cell Number in Series [Pieces]
Maximum Power (Pmax) [W]
Maximum Power Voltage (Vmp) [V]
Maximum Power Current (Imp) [A]
Open Circuit Voltage (Voc) [V]
Short Circuit Current (Isc) [A]
Cell Type
Maximum System Voltage [V]
Factory Installed Bypass Diode
Weight [kg]
*HIT= Hetero junction with Intrinsic Thin-layer
Note: The values in the above table are nominal.
(Module type : HIP-190BE3, -180BE3, -175BE3, -167BE3B¶B¶B¶
dimensions in mm
Front
Note: A module is installed on a platform
Note: A module is installed on a mounting
:w with standard setting range (shaded)
structure rail with standard setting range
(shaded).
HIP
HIP
-190BE3
-180BE3
-175BE3
96
96
190
180
54.8
54.0
3.47
3.33
67.5
66.4
3.75
3.65
HIT* ( hybrid of a-Si and mono c-Si)
760
760
Yes
Yes
14
14
Dimensions
B¶B¶B¶
B¶B¶B¶
B¶B¶B¶
with connector and cable)
Label
negative ( - )
Connector (MC Plug)
Mounting Place (4places)
Side
Section A-A'
Figure2: Dimension
SPECIFICATIONS
HIP
HIP
Notes on specification
-167BE3
(1) Powered
96
96
measured
175
167
Condition Irradiance of : 1000W/m
52.9
51.4
25
3.31
3.25
spectral irradiance per IEC 60904-3.
65.7
64.9
(2) The current output for these
3.64
3.63
modules
Specifications
Standard test conditions. These
760
760
conditions may not be frequently
Yes
Yes
observed in actual practice.
14
14
Mechanical Loading
The modules should be mounted at
the 4 or more points as shown in Fig1,
Fig2. Then, a maximum loading of
2170N/m
the module surface is possible.
CERTIFICATION
The
167BE3
requirements of IEC61215, Electrical
protection Class II and the CE mark.
Junction Box
WIRING
positive ( + )
General
• All wiring should be done in
accordance with applicable electrical
codes.
• All wiring should be done by the
qualified licensed professional.
• Wiring should be protected to help
ensure personal safety and to prevent
its damage.
• All modules connected in series
should be of the same model
number/type.
• Do not connect modules in parallel
Backside
without using a connection box.
3
Printed in Japan 04.09.22.000
specifications
are
at
Standard
Test
o
C cell temperature and solar
as
shown
in
the
is
measured
2
(45PSF, in static state) on
HIP-190BE3, 180BE3, 175BE3,
Module comply with the
2
,
at
Advertisement
