Siemens 7XV5655-0BB00 Manual page 54

Manual 7XV5655-0BB00
Change passwords.
ATZ
ATZ=master password Changes the master password (default empty)
ATZ1..9=User password Assign user password.
ATZ1? Queries the set password for checking
ATZ=<Enter>
ATZ1..9=<Enter>
Entries are only possible in password configuration mode (see ATP).
Up to 9 passwords may be saved in the modem.
Passwords consist of up to 8 characters, no distinction is made between upper and
lower case letters. Special characters are allowed.
If the master password has been forgotten, the device must be sent in.
(For address, see last page of this manual)
Outputs the firmware version.
AT%V
AT%V
Loads the default configuration.
AT&F
AT&F
This command loads the factory (default) settings. The IP address and all settings that
are only set in password configuration mode are retained.
Note:
The following registers were not reset:
Register Definition
S1 Number of rings (read only)
S31 Baud rate
S32 Parity
S33 Data bits
S34 Stop bits
S81 Password protection
S99 Time between two rings
S100 Own IP
S101 Default gateway
S103 Subnet mask
S104 MAC address
S110-119 Valid IP addresses for call accept
C53000-G1176-C175-3
Deletes the master password.
Deletes the user password.
(is equivalent to ATI3)
Page 54 of 79
This command is also
only executed with the
currently set baud rate
and the appropriate
data format, i.e. the
modem does not
feature automatic baud
rate detection.
SIEMENS AG