Husqvarna TS73R Standard Operating Procedure

Standard Operating Procedure
HUSQVARNA TILE SAW 9" TS73R
Version 3 Issue date: 6/05/2017
Page 1 of 4
Section 1: Equipment Identification and Supplier details
Name
Recommended Use
Manufacturer / Importer
Emergency Contact details
Links to safety information
Does this equipment require a daily check or inspection and entry in a log book?
Section 2: Emergency Stop
Section 3: Hazards Identification
Husqvarna Tile Saw 9" TS73R
Water-lubricated cutting of marble, stone, granite, brink and
facings, including porcelain, glazed tiles ceramics etc.
Husqvarna Construction Products
NZ Importer Youngman Richardson
www.yrco.co.nz
Garry Bull (Upper Hutt Hire) 027 742 6583
None at this time
In an emergency Turn the switch off.
Alternatively unplug the power saw.
If the electrical cable or components are damaged, you are
authorised by Upper Hutt Hire to cut the plug off the power
cable, to prevent inadvertent use.
DANGER: High Voltage! Risk of Electrocution!
Always use a residual-current circuit breaker (RCCB), Ground
Fault Circuit Interrupter, Transformer or other suitable
electrical Safety device.
When operating outdoors, use an extension cord suitable for
outdoor use.
DANGER: RISK OF AMPUTATION!
NEVER place hands and feet in the feed anywhere near the
blade. RISK of limbs being severed. If a blockage occurs turn off
the engine, unplug it, and allow machine to come to a
COMPLETE STOP before clearing obstructions.
DANGER: RISK OF FLYING DEBRIS.
Always wear eye protection
ELECTRIC MOTOR = POTENTIAL IGNITION SOURCE
Do not operate in areas where there is fuel vapour, LPG, or
high levels of flammable dust.
Do not operate in explosive atmospheres such as in the
presence of flammable liquids, gases or dust.
20 Goodshed Road Upper Hutt
Phone 04 528 4473
No