Table of Contents
Advertisement
3.1
Station Address Setting Switch
■Station address setting switch
The station address setting switch is a hexadecimal rotary switch for deciding the station address
on the TC-net I/O loop, STN-H for setting the upper digit address of the station address and
STN-L for setting the lower digit address There is. For the station address, set the address (1 to
254) allocated at system construction with HEX (hexadecimal) code. All nodes in the system are
assigned addresses of different values.
STN-H
STN-L
Remark
・ For setting, use a small slotted screwdriver.
Set the station address with HEX (hexadecimal).
For example, if the address value is 28, conversion to hexadecimal will be '1C'h, so set
STN-L side -'C' on STN - H side - '1'.
Note
・ Be careful so that the address does not overlap with other nodes.
◆Important
・ Set the station address setting switch before turning on the power supply.
Unified Controller nv-pack series TC-net I/O Loop PCI Express
Table 3-1 Set station address
Name
Description
Setting range : 01h to FEh
STN-H(upper digit address) : 0 to Fh
STN-L(lower digit address) : 0 to Fh
3.1 Station Address Setting Switch
TM
Card JTLI41 Instruction Manual
11
Advertisement
Table of Contents
