Wiring - Toshiba nv-pack JTLI41 Instruction Manual

4.3

Wiring

On the front panel of the card, there are TC-net I / O loop connectors (LP1 and LP2).
Wire the transmission cable to LP1 and LP2 as shown below.
LP1 LP2
Slot 51
Slot 50
Figure 4-9 Appearance and wiring during card mounting
Clamping cables
After connecting the cables, clamp them so that the weight and bending force of the cables will not
directly affect the connectors. Table 4-1 shows the allowable bending radius of the cables for
laying and fixation. Make sure that the cable bends are not smaller than these radii.
Cable
Optical fiber cable
Note
 The allowable bending radius depends on the optical fiber cable product. Follow the bending radius
of the optical fiber cable specified by the manufacturer.
Unified Controller nv-pack series TC-net I/O Loop PCI Express Card JTLI41 Instruction Manual
LP2 LP1
Slot 52
Slot 53
Optial fiber cable
Table 4-1 Allowable Cable Bending Radius
External
Diameter (mm)
5mm
Allowable Bending Radius
Clamped Connected
50mm 50mm

4.3 Wiring

23