Motorola Avigilon H5M Installation Manual page 24

Note: This process is the same for both surface and in-ceiling mounted cameras. Surface mount is
shown in the following figures.
After you install the mounting adapter, mount the camera body to the adapter, using the following steps:
1. Install the protective cable boot to protect the Ethernet connection from water and moisture.
a. Thread one end of the Ethernet cable through the protective cable boot.
Ensure the orientation of the cable and boot matches the one shown in the image.
b. Crimp the Ethernet cable.
c. After you connect the cable to the camera, slide the boot over the Ethernet port.
2. Connect the Ethernet port attached to the camera to the Ethernet cable that was pulled through the
adapter.
The connection status LED indicator will blink when the connection is being established and will turn
off once streaming has started.
Installing the Camera Body to the Mounting Adapter 24