Selecting An Operator Page To Display; Enabling Operator Page Autoscroll - ABB LWT300 Series User Manual

8 Highlight the value that you want to display and press OK.
9 (if necessary) Repeat steps 6 through 8 to configure all remaining values.
Once you have completed the configuration, exit the Display menu.

Selecting an Operator page to display

If necessary, you can choose which Operator page to display as the default display. When first
connecting the instrument, Operator page 1 is selected by default.
To select another page:
1 From the startup display, press the left action key (
2 Using the Up or Down arrow keys, highlight the Operator Page that you want to use by default
NOTICE
The Signals View and Diagnostics pages can be selected, but cannot be used as
Operator pages. These pages are mostly used for troubleshooting purposes.
3 Press Select. The page is selected and you automatically return to the startup display where the
newly selected page appears. For more information on configuring the content of Operator pages,
see "Configuring Operator pages" on page 40).

Enabling Operator page autoscroll

The autoscroll feature allows you to move automatically between Operator pages at a set time interval.
This is useful when you simply want to record specific values manually without touching the instrument.
This feature is disabled by default.
To enable autoscroll:
1 Select Display > Autoscroll.
2 Press Edit.
3 Select one of the time intervals (3, 5, 7, 10 Seconds) that you want to set as a time delay after which
Operator pages scroll automatically.
4 Press OK.
When the autoscroll feature is enabled, a spinning icon appears next to the Operator page number.
—
Figure 31 Autoscroll icon next to the Operator page number (4)
Autoscroll icon
NOTICE
If the feature is activated and you want to deactivate it, highlight Off instead of the
already selected time interval.
). The Operator Menu appears.
Configuring the instrument
41