D-Link DP-G310 Quick Installation Manual page 2

Connecting The DP-G30 To Your
Network
First, insert one end of a straight-through CAT5 Ethernet RJ-45 cable into
the "Network Port" (shown below.) Connect the other end of the cable to the
LAN port of the gateway or
the DP-G310 until you are advised to do so.
Warning!
Only a USB printer may be connected to the USB port of the DP-G310. Do not
connect any other USB device to the USB port; doing so may damage the unit,
voiding the warranty for this product.
Next, make sure that the Printer is turned OFF.
Using the USB cable, connect one end of the cable to the USB port of the
DP-G310 (shown below) and the other end to the USB port of the printer.
Turn ON the printer.
Receptor for
AC Power
Adapter
Then, plug one end of the power adapter into the DP-G310 and the other
end into your electric outlet. The DP-G310 will turn on and begin a self-test.
For Mac OS printing, please refer to manual (.pdf) located on the CD-ROM.
switch. Note: Do not connect the power cord to
USB Port
2
Network Port