Related Manuals for ABB M4M
Summary of Contents for ABB M4M
- Page 1 — CO MM I S S I ON I NG G UI D E L IN E M4M Firmware update Getting started 2 CS G 4 45 053 D02 01 [ V. 1.00] 1 /10...
-
Page 2: Table Of Contents
1 Material and tools needed ......................3 2 Initial settings on M4M device ....................3 M4M Modbus RTU (M4M 20 Modbus, M4M 20 I\O, M4M 20 Rogowski, M4M 30 Modbus, M4M 30 I\O, M4M 30 Rogowski) ............. 3 M4M Ethernet (M4M 20 Ethernet, M4M 30 Ethernet) ............4 3 FW update procedure via EPiC desktop ................... -
Page 3: Material And Tools Needed
FW. • In case of product communicating via Modbus RTU, please follow the dedicated section "M4M Modbus RTU” for both M4M 20 and M4M 30 ver- sions • In case of M4M product communicating via Modbus TCP/IP, please follow the dedicated section "M4M Ethernet"... -
Page 4: M4M Ethernet (M4M 20 Ethernet, M4M 30 Ethernet)
• Protocol = 8E1 (8 bit data, even parity and 1 bit stop) • RTU address for Master Device = 1 • RTU address for M4M slave device: to be inserted starting from 2 to 247. TIP: Each device shall be provided with a different slave address. -
Page 5: Fw Update Procedure Via Epic Desktop
FW update B. Open EPiC desktop in the “Scan” tab C. Configure the scanning via communication protocol 1. Via Modbus RTU (M4M Modbus) Click on “Configure” under Serial port. Select port name, baudrate, parity, slave addresses of all devices connected via Modbus RTU to be updated. - Page 6 2. Via Modbus TCP/IP (M4M Ethernet) Click on “Configure” under Ethernet In the section “IP addresses”, insert the IP address of M4M Ether- net in the list of IP addresses to be scanned. It is possible to either add IP addresses one by one (“Use IP address list”), or input IP ad- dress range (“Use IP address range”).
- Page 7 E. EPiC desktop allows to visualize the product-related pages, including dashboard and Modbus map reading via Classic View. In the Information section of the Dashboard it is possible to check what is the firmware version currently installed on M4M F. Click on “Tools” 7/ 10...
- Page 8 G. Click on “Firmware Update” H. Click on the “Firmware update” option in order to upload the FW version previously downloaded from the ABB Library here. Please extract the .enc file from the downloaded .zip. Please click on the “Select file from Computer” option and select the .enc related to the latest FW version of M4M.
- Page 9 100%, M4M will start the rebooting process for few minutes while checking the new firmware. The screen will turn black and the red LED lights will be on. Please do not unplug the M4M’s auxiliary power sup- ply during this operation.
- Page 10 M 4M FIRM WAR E UPDATE L. As the FW update is completed successfully, a banner will appear on Ekip Connect to inform the user. 1 0/1 0...