Table of Contents
Advertisement
(Continued from previous page)
• Type n and press Enter to disable the STB software update. Then, press Enter again to
return to the Command > prompt.
3. At each of the following prompts, type the number of hours and minutes to delay before
the STB software update is initiated, as well as the desired duration (in minutes) for the
update window. Note that all three of these fields require numerical values. Press Enter
after each entry.
If applicable, you can also press Enter at each prompt to accept the default value in
square brackets.
Enter the number of hours to delay before starting [12]:
Enter the number of minutes to delay before starting [0]:
Enter the maintenance window duration in minutes [25]
Note: The system will not allow a maintenance window that is less than 10 minutes or over
four hours. The default value (25 minutes) is the minimum time span typically recommended
for an update. It is also recommended that you schedule the maintenance window during a
time when the STB is not likely to be in use.
After you enter a valid maintenance window duration, the system will display confirmation,
for example:
Configured STB Update... OK
4. Press any key to return to the Satellite Receiver Menu Command > prompt.
Read STB Model
Displays the ViP 222k model number, for example: Model = ViP222k-HD .
Read STB Software Version
Displays the ViP 222k software version, for example: Software_Version = X398RPLB-N .
Enable/Disable RC Functions
Allows you to enable or disable the use of an IR remote control with the ViP 222k. At the
Enable remote control (y/n)? prompt, either:
• Type y and press Enter to enable the use of the remote control with the STB. The system
will confirm the setting:
RC functions are enabled
• Type n and press Enter to disable the use of a remote control. The system will confirm the
setting:
RC functions are disabled
Return to Main Menu
Returns you to the Main Menu.
206-4180
Configuration Options (Cont.)
23
Advertisement
Table of Contents
