Advertisement
• If the punch unit is open, do not carry the front.
Do not carry the unit while open.
2. Installation procedures
Note:
When mounting the punch kit, mount it before
mounting the finisher to the main unit.
(1) Turn OFF the power switch and unplug the
power cord from the power outlet.
(2) Remove protective tape and protective materials
and take out accessory parts.
(3) If the Finisher FS-533 is mounted on the main
unit, remove the finisher.
Note:
<C554e/C454e/C364e/C284e/C224e/C554/C454/
C364/C284/C224/C368/C308/554e/454e/364e/
284e/224e>
See the installation manual for the Finisher FS-
533 for removal instructions.
<367/287/227>
See the installation manual for the Mount Kit/Fin-
isher MK-602/FS-533 for removal instructions.
(4) Attach the three supplied seals to fill the square
holes in the output tray of the main unit as shown
in the illustration.
(5) Place the punch unit upside down, then install
the stopper arm at the position shown in the illus-
tration. (One supplied screw A)
E-2
Advertisement
