Advertisement
9. trOubleshOOtInG
prOblem
The device does not heat
up. (In the ON position, the
power switch does not light.)
The unit does not heat up.
(The light does not come on
and the power switch is on.)
The steam flow is irregular,
the
Appliance "coughs".
Water comes out of the
accessories or
The head of the broom, but
no steam.
Steamer generates a large amount of steam that can condense water in the hose, and the extension tubes after a cooling period or
of use of the device.
The broom head does
not stay attached to the
extension tubes.
The handle becomes hot.
Weee reGulatIOns
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
envIrOnment prOtectIOn
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey Group, kempson Way, suffolk business park, bury st edmunds, suffolk. Ip32 7ar
01284 757500
© Jack Sealey Limited
cause
1 - The device is not connected.
2 - The device is damaged.
1 - The Steamer is empty.
2 - Scale has accumulated in the water
tank.
3 - The device is damaged.
1 - First use after filling the tank
2 - The level is low.
3 - The steam hose is bent / folded.
4 - Scale has accumulated in the tank.
1 - Steam condensed in the hose.
2 - The water has not heated enough.
3 - The water tank is too full.
1 - The adapter is not inserted into the
bottom of the tubes.
When hot steam passes through the
handle, it warms up.
01284 703534
Original Language Version
sOlutIOn
1 - Check the plug / socket.
2 - Disconnect and contact Technical Support.
1 - Add water by following the instructions.
2 - Clean the tank.
3 - Disconnect and contact Steamer Technical Support.
1 - Release the condensed water by pressing the
steam trigger.
2 - Add water by following the instructions.
3 - Tighten the hose.
4 - Clean the tank according to the instructions.
1 - Direct the tip towards a bucket and unload.
2 - Wait for the rise of steam pressure.
3 - Turn off the power, allow the unit to cool down and
drain the water from the tank. Empty this water by
operating the steam trigger over a bucket or sink.
make sure the spring button is fully engaged in the
hole in the tip.
In case of discomfort, use a glove.
sales@sealey.co.uk
www.sealey.co.uk
VMSC01 | Issue:1 04/12/19
Advertisement
