Time Search 43 - Philips DV910VHS98 Owner's Manual

DV910(H9100).QX33 01.8.9 10:26 AM
VCR
Follow the steps below to program the DVD/VCR to search for-
ward or backward on a tape a specific length of time.There must
be a tape in the DVD/VCR.
Before you begin, place the DVD/VCR in VCR mode. Press the
OUTPUT SELECT button so that the green VCR OUTPUT light
appears on the front of the DVD/VCR. Press the VCR/TV button
so that the VCR/TV light appears on the front of the DVD/VCR.
1
Press the VCR button, then press the SEARCH
MODE/TIME SEARCH button.
TIME SEARCH
0:00
ENTER SEARCH TIME
2
Within 10 seconds, use the Number buttons to enter the
desired length of time you want to skip forward or back-
ward. For example, for 1 hour, 25 minutes, press Number buttons
1, 2, 5. Or, for five minutes, press Number buttons 0, 0, 5.
3
Within 10 seconds, press the Fast Forward g button or
the Rewind h button. The DVD/VCR will skip over the spec-
ified length of time, then begin playback.
Page 43

Time Search 43

POWER
MARKER
SETUP AUDIO SUBTITLE ANGLE
MENU TITLE
OK
MODE RETURN
OUTPUT SELECT
DVD VCR
SKIP/CHANNEL CHANNEL/SKIP
H/ L K /G
3 B
E
D
C
REC
F
/OTR
A-B
CLEAR
REPEAT
DISPLAY
1 2 3
STATUS/EXIT
SEARCH MODE
2
4 6
5
TIME SEARCH
SLOW
7 8 9
ZOOM
+ 10 0
TIMER SET VCR/TV MEMORY SPEED
Helpful Hints
• If you want to search for more than
59 minutes, you must enter the
length of time in hours and minutes.
For example, to search forward 70
minutes, press 1,1,0 at step 2.
• You can not do a Time Search while
recording.
• To remove the Time Search display,
press the SEARCH MODE/TIME
SEARCH button again.
• To cancel a Time Search that is in
progress, press the Stop C button.
• If the end of the tape is reached
during a Time Search, the Time
Search will be cancelled.The
DVD/VCR may rewind the tape.
Details are on page 45.
1