Toro 1436-501 Installation Instructions

Arctic Cat
Installation Instructions - Accessory Kit
LXC Windshield Kit
 NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain
these Installation Instructions for future reference.
Kit includes:
p/n QTY
2441-243 1
2441-242 1 Top Sealing Foam
2441-244 2 Gas Spring
2441-241 4 C-Clamp
2441-247 1 Grab Handle
2441-245 1 Grab Catch Support
2441-246 1 Grab Catch
* 2 Machine Screw (M6-10 x 14 mm)
* 2 Machine Screw (M6-1.0 x 16 mm)
* 2 Machine Screw (M6-1.0 x 20 mm)
* 2 Machine Screw (M6-1.0 x 25 mm)
* 2 M6 Fender Washer
* 4 Flange Lock Nut
* 4 Lock Nut (M8-1.25)
* 2 Grab Catch Screws w/Rubber Well Nuts
* 4 Rubber Washer
* 4 Fender Washer
0453-731 1 Instructions
*Included in Hardware Kit (p/n 1436-705)
1. Assemble Grab Catch (B) onto Grab Catch Support (C)
using two Machine Screws (M6-1.0 X 16 mm) (A) and
two Flange Lock Nuts (D) (finger tighten at this time).
See Fig. 1.
Fig. 1
Prowler
®
(1436-501)
DESCRIPTION
Windshield Glass
UTV-160A
2. Secure the grab catch support (D) onto the lower center
part of Windshield Assembly using two Machine
Screws (M6-1.0 X 14 mm) (A), two Fender Washers
(#B), and two Rubber Washers (C). See Fig. 2.
Fig. 2
 NOTE: If Roof Kit (p/n 1436-500) is installed, go
to step 3. If not, go to step 4.
3. Remove and retain the C-clamps securing the roof to
the ROPS tubes; then remove the roof. See Fig. 3.
Fig. 3
1
Form No. 0453-731
UTV-161A
UTV-162