Timer / Handling Of Louver Falling Off / Handling Of Full Water Tank - Panasonic F-YWP33N Operating Instructions Manual

Timer / Handling of louver falling off / Handling of full water tank

Press button during operation to set up
desired auto power off time. Press this key to
cycle through from 1 to 12 hours (press and hold
it to cycle automatically).
Louver fall off
Installation of louver
1
Point and insert holes to the
left to thud at left side of your
product
2
The louver is flat and slightly
bent at its center part.
3
Insert right hand side of it to
machine body.
The product stops operation automatically when water in tanks reaches the full level (about 5.2 liter).
The LCD indicator turns orange for 10 seconds then goes off. The water
keeps on flashing. (If the water full sound is ON (P18), the buzzer beeps for 6 seconds together with the
orange indicator.)
Please empty water tank as described below
Hold the machine body
steady with one hand
and gently remove
water tank out of it with
another hand
Without hitting each
other (cause to failure)
Pull up the water tank cover to
open the drainage opening.
Open the
drainage opening
When
is flashing...
14
To use timer for power off
Handling of louver falling off
Hole to the left
Thud to the
left
Handling of full water tank
Tank cover
Water level
display window
Water
full
mark
The timer displays remaining time once it is set.
Take example. For timer set to 9 hours and with 8
hours to go, it displays 8 hours.
The timer keeps count down once it is set even
after the water tank is full and operation aborted.
Set timer in cloth drying mode will prevent
ECONAVI indicator, auto stop indicator, and cloth
humidity indicator from lighting up.
Turn the louver upward and
downward for easy inserting
Move water tank
handle to drainage
position
Hold water tank
handle and its
bottom to drain it.
Water tank installation
Close the drainage opening, insert water tank
into place
Close both water tank cover and drainage
opening for installation (or the water tank may
fail to install into place and may lead to water
leak)
Push water tank into place. In case of damaged
poorly installed water tank the water full
indicator may fail to flash and system operation
may fail to start. Please remove the water tank
and install again.
display and indicator