Toshiba B-492L Owner's Manual page 62

APPENDIX 4 SYSTEM MODE
A4.5 Printer Parameter
Fine Adjustment
(Cont.)
NOTES:
1. The fine adjustment value
equals the sum of the fine
adjustment values set by the
PC command and this
parameter. The maximum
ribbon motor voltage fine
adjustment value is 15.
When the addition of values
reaches the maximum, the
value remains unchanged
even if subsequent fine
adjustments are made.
2. Each step corresponds to
5% of the standard voltage
and up to 75% of the
voltage can be decreased.
Only for the feed motor, the
voltage can be increased up
to 50%.
3. Please make this adjustment
if ribbon errors occurs
though the ribbon has not
jammed or ended.
If the problem cannot be
resolved, please contact
your nearest TOSHIBA TEC
service representative.
Ribbon Motor Voltage Fine Adjustment (Feed/Rewind Motor)
With this parameter you can fine adjust the Ribbon Motor Voltage
(Torque). With "<3>ADJUST SET" displayed, press the [PAUSE] key
7 times to enter the Ribbon Motor Voltage Fine Adjustment (Rewind
Motor) menu.
.
To change the screen to the Ribbon Motor Voltage Fine Adjustment
(Feed Motor), press the [PAUSE] key again.
[RESTART]
[FEED]
[FEED] key: Pressing the [FEED] key once causes a –1 step
change, down to –15 steps.
[RESTART]key: Pressing the [RESTART] key once causes a +1 tone
change, up to +0.
After completing the fine adjustment, press the [PAUSE] key.
A4-12
A4.5 Printer Parameter Fine Adjustment
Rewind Motor
Rewind Motor
Feed Motor
Rewind Motor
EO1-33032
Feed Motor