Advertisement
Installing the Module Enclosure into rack
This server must be mounted to a rack which conforms to EIA standards for use.
Refer to the manual that comes with your rack for how to install the rack, or consult with your sales
representative.
856-129811-101-00
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, refer to
Safety precautions in Precautions for Use.
Use only in the specified environment.
Do not connect the ground wire to a gas pipe.
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety precautions in Precautions for Use.
Do not carry or install the server by a single person or two persons.
Do not install the server so that the load may be concentrated on a specific
point.
Do not install any components only by a single person. Confirm that hinge pins
of the door are completely secured in place.
Do not pull out the server from the rack when the rack is unstable.
Do not leave more than one device being pulled out from the rack.
Do not provide the wiring for the server to exceed the rating of the power
supply.
Do not use in the environment where corrosive gas is generated.
Important
Temperature increases and airflow in the rack
If multiple devices are installed, or if the inside of the rack is not sufficiently
ventilated, the internal temperature rises due to the heat emitted from each device,
which may result in a malfunction. Review airflow in the rack and room and take
sufficient measures so that the internal temperature will not exceed the operational
temperature during operation.
Air enters the server from the front and exits from the rear.
WARNING
CAUTION
3 / 11
Advertisement
