Advertisement
Mounting rails
1. Mount the rail marked with "RIGHT" to the right side viewed from the front of rack.
Similarly, mount the rail marked with "LEFT" to the left side of rack.
Engage the angle protrusion of rail with the hole on 19-inch rack. Mount the rail while pushing
the locking mechanism until it is securely locked.
The figure below shows the front left side. Mount rails on rear left side, front right side, and
rear right side in similar way.
The height of rails mounted on left and right sides must be level.
Installing/Removing the Server
856-129811-101-00
Important
Confirm that the rails are securely locked so that they will not fall off.
Although the rail assembly may be somewhat unsteady, it is not defective.
Tips
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety precautions in Precautions for Use.
Do not lift the server with two or less persons.
Do not drop.
Do not leave the server being pulled out.
Do not install with the cover removed.
Do not get your fingers caught.
1
Push
here
2
CAUTION
5 / 11
Advertisement
