Print Format - Toshiba TEC EM1-31074 Owner's Manual

11. PROGRAMMING PROCEDURES

11.10 PRINT FORMAT

Normal Mode
Menu Group: 2
Item No.:
The SL-9000 can memorize 5 different print formats. After print formats are set, you can call them by
entering the print format number.
<MENU>
Group 2
CHANGE
Issue method
PLU
Batch
Select the Item for adjustment.
1 gradation
= 0.154mm (1 dot)
1 gradation
= 0.462mm (3 dots)
1 gradation
= 0.462mm (3 dots)
Only when using the bar code
change label with pre-feed area.
(This adjustment cannot be made
for the Variable Length Label.)
NOTES:
1. When a commodity name position is adjusted, an address position will move automatically.
2. When entering the other label format #, fine adjust values are initialized.
3. Selecting label format numbers other than those provided in Table 2 results in an error.
4. When selecting a variable length label format, rectangles are printed instead of print items when
test printing.
5. Pressing the
6. Be sure to press the SET NEXT key when a label format for batch printing with backing paper
is selected.
ESB Limited Spec. Mode
Item No.: 3
0
Select the print format # which
0
allocates the label format #
by the NEXT PLU
On-demand
Select "SENSIBILITY ADJUST"
by pressing the key.
When Batch Printing with backing paper is
selected, the sensitivity of the label sensor will
be set by pressing the SET NEXT
issuing label.
Enter the correct label feed
value.
(Range: 0~199)
Enter the correct value for
commodity name position.
(Range: 0~9)
Enter the correct value for
address position.
(Range: 0~15)
Enter the correct value for
pre-feed area.
(Range:
key allows you to select a print format number from 1 to 5.
Enter the label format #.
–
key or key.
SET
NEXT
key before
ENTER
ENTER
ENTER
ENTER
0~65)
11-18
(Refer to Table 2)
j
FEED TEST
Incorrect
j
j
j
j
11.10 PRINT FORMAT
Is print
Correct
position
correct?
CHANGE
PLU
<MENU>
PROG.
Group 2
Main
ESC.
<MENU>