Installing Batteries In The Remote Control; Vcr / Dvd Recorder Switching; Panel; Dvd Mode - Toshiba D-VR17KB Owner's Manual

E9GA0BD_EN.book Page 15 Monday, March 26, 2007 10:14 AM
Installing Batteries in the
Remote Control
Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the polarity
indicated inside the battery compartment.
1 2
Caution
• Incorrect use of batteries can result in hazards such
as leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus and minus ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used
for a month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions
for environmental protection that apply in your
country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
About the Remote Control
• Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
REC
VCR
ON / STANDBY
Remote control
• The maximum operable range as follows:
Line of sight:
Either side of centre: approximately 7 m within
• Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
• Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
• Replace the batteries when the operating range of
the remote control reduces.
3
PROGRAM
DUBBING VCR/DVD REC
DVD
VCR DVD
Within about
7 m
approximately 7 m
30 degrees

VCR / DVD Recorder Switching

Because this product is a combination of a VCR and a
DVD recorder, you must select first which component
you wish to operate.
PROGRAM
REC DUBBING
VCR
ON / STANDBY
VCR/DVD
VCR DVD
DVD indicator
VCR indicator
VCR mode
Press [VCR] on the remote control.
(Verify that the VCR indicator is lit.)

DVD mode

Press [DVD] on the remote control.
(Verify that the DVD indicator is lit.)
Note
• You can also press [VCR/DVD] on the front panel to
switch between DVD and VCR mode.
• You cannot switch to the mode (DVD or VCR) that is
in the timer-standby mode.
VCR/DVD REC
DVD
VCR DVD
15
EN