Vertical Cut Alternative A - ABB 2RCA035147 Operating Manual

14
—
7.1 Vertical cut Alternative A (left/left)
To set the cutting head for vertical left guiding:
turn the cutting head so that the "VERTICAL Left"
marking is at the top.
Use the "VERTICAL Left" position with cuttings (6-9)
and (10-13) as shown in section 2 (alternative A).
Push the cutting head firmly against the left side
cut-out edge starting from the top.
Make four cuts (6-9) below each other, starting
from the top.
It is recommended to make overlapping cuts to
avoid sharp edges in between the cutting
junction points.
For the last vertical cut, push the cutting head
firmly against the left side cut-out edge as shown
in the picture.
Repeat the procedure for cuts 10-13, starting
from the top.