Vertical Cut Alternative C - ABB 2RCA035147 Operating Manual

—
7.3 Vertical cut Alternative C (right/right)
To set the cutting head for vertical guiding:
turn the cutting head to the "VERTICAL Right"
position facing up.
Use the "VERTICAL Right" position with cuttings (6-9)
and (10-13) as shown in section 2 (alternative C).
Push the cutting head firmly against the right side
cut-out edge starting from the top.
Make four cuts (6-9) below each other, starting
from the top.
It is recommended to make overlapping cuts
to avoid sharp edges in between the cutting
junction points.
For the last vertical cut, push the cutting head
firmly against the right side cut-out edge as shown
in the picture.
Repeat the procedure for cuts 10-13, starting from
the top.
17