To do a check of the V-belt
WARNING: Do not operate the product
without the V-belt cover installed.
1. Stop the motor and disconnect the power cord from
the power source.
2. Remove the V-belt cover.
3. Examine the V-belt (A) for damages and wear.
Replace the V-belt if it is necessary.
A
4. Examine the tension of the V-belt.
5. If the tension is not sufficient, turn the adjustment
screw (B). The tension is correct when the V-belt can
be pushed in 3 mm/0.12 in. with a force of 20 N/4.5
lbf.
6. Install the V-belt cover.
To set the product in maintenance
position
WARNING: Disconnect the power cord from
the power source to prevent accidental start.
The maintenance position is used for all maintenance
procedures in the blade area below the product.
10
•
To clean or replace the blade shafts
1. Remove the screws and washers (A) that hold the
B
2. Remove the outer ring.
Tilt the product forward until it is stable on the
support frame.
outer ring on the blade shafts.
A
1132 - 001 - 06.04.2020