Equipment Supplied; Equipment Required - Philips FM92E Manual

10: Equipment Supplied:

•
Philips FM92E band transceiver
•
Remote Control Head or Speaker [for local control head].
•
2764 EPROM [already programmed for 6 meters – 77 FM channels].
•
VHF Signal Generator
•
RF Power Meter
•
De-Soldering station
•
Soldering Iron
•
12 volt meter.
•
Tuning stick.
•
Grid Dip Oscillator.
•
50ohm RF cables.
•
This document plus frequency v channel page.
•
50 watt plus soldering iron with big flat tip.
•
Large File [rasp]
•
Methylated Spirits
•
Tin Snips *
•
Philips Screwdriver *
Note: * = Bring your own if you have one.

11: Equipment Required:

•
Soldering Iron [if needed]
•
Solder wick [if needed]
•
Stanley Knife or Scapple or Box Cutter
•
Tin snips [if needed]
•
Pair of small tweezers
•
Engraver with grinder [if needed]
•
Hot glue gun [if needed]
•
12 volt meter [if needed]
•
Small plastic GLAD bag for holding screws.
•
A4 plastic GLAD bag for holding covers.
•
Can of WD40.
•
Mr Sheen, Armour-all or similar.
•
1cm or 2cm paint brush for cleaning.
•
Sponge or cloth for cleaning.
•
Masking Tape for cleaning.
•
Tooth brush for cleaning.
•
Can of black paint [if needed].
•
In-Line Fuse holder & 8 or 10 amp fuse.
•
5 pin DIN plug [for speaker] or 3.5mm plug.
•
0.80mm [B&S 20] Enamelled Copper Winding Wire. [Jaycar WW-4020] will cover aprox 10 sets.
•
0.63mm [B&S 22] Enamelled Copper Winding Wire. [Jaycar WW-4018] will cover aprox 20 sets.
•
12 Volt 10 Amp Power cable.
•
1 of 100K ohm potentiometer. Jaycar # RT-4366
Philips FM92E Conversion to 6 Meters:
[at no cost to members]
*
*
[to be supplied by each member]
Version 3.9 Page 13