Advertisement
Installation Guide
Terminating a DC Input Power Cable with a Connector
A
Stripping a Power Cable
Strip a power cable based on the stripping indicator.
1
12 mm
10 mm
2
Use a pair of diagonal pliers to trim off the -48 V power line.
8 mm
Cable core
B
Installing Cord End Terminals
1
Install cord end terminals onto the cable cores.
NOTE
For the stripping length, see the stripping
indicator on the PI.
8 mm
3
Strip the 0 V ground line in the same way.
8 mm
Cable core
Crimp all cord
2
end terminals.
CAUTION
After crimping a cord end terminal, check whether the cable core is exposed
outside the terminal. If the cable core is exposed, recrimp the terminal.
After the power switch is turned on, sparks may be generated at exposed cable
cores when an inappropriate operation is performed.
07
Advertisement
