Toro TX Platform Installation Instructions Manual

TX Platform
Gasoline-Powered TX Compact Utility Loader
Model No. 22475—Serial No. 270000001 and Up
Model No. 22476—Serial No. 270000001 and Up
Safety
General Operation
•
Do not modify the platform or use it on
non–approved machines.
•
Ensure that the platform is properly attached to the
machine and is in good working order prior to use.
•
Allow only the machine operator on the platform.
•
Do not allow use of the platform by untrained
operators.
•
Use appropriate personal protective apparatus for
eyes, feet, hands, and head.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use extra care when operating in reverse.
•
Dismount and latch the platform in the transport
position when loading and unloading the machine.
•
Do not place your feet under the platform.
•
Slow down before turning. Sharp turns on any
terrain may cause loss of control.
•
Do not step off of the platform with the load raised.
•
Keep your hands, feet, hair, and loose clothing
away from any moving parts.
•
Do not try to stabilize the traction unit by putting
your foot on the ground.
•
Do not operate platform on rough and uneven
terrain.
•
Ensure that you operate the platform in areas
where there are no obstacles in close proximity
to the operator. Failure to maintain adequate
distance from trees, walls, and other barriers may
result in injury as the platform backs up or turns
during operation if the operator is not attentive to
the surroundings. Only operate the unit in areas
where there is sufficient clearance for the operator
to safely maneuver the platform.
•
Ensure that the area is clear of other people before
operating the traction unit with the platform. Stop
the traction unit if anyone enters the area.
•
Do not exceed the rated operating capacity, as
the traction unit with the platform may become
unstable which may result in loss of control.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Service
•
•
•
•
•
Register at www.Toro.com.
Installation Instructions
Stop the engine before performing any service,
repairs, maintenance, or adjustments
Keep nuts and bolts tight. Keep equipment clean
and in good condition.
Never tamper with safety devices. Check safety
systems for proper operation before each use.
Stop and inspect the equipment if you strike
an object. Make any necessary repairs before
restarting.
Use only genuine replacement parts to ensure that
original standards are maintained.
Original Instructions (EN) All Rights Reserved *3439-615* A
Printed in the USA
Form No. 3439-615 Rev A