Husqvarna K 7000 Ring Operator's Manual page 10

2. Push the power trigger lockout and make sure that it
goes back when you release it.
3. Make sure that the power trigger and power trigger
lockout move freely and that the return springs
operate correctly.
4. Start the product and apply full speed.
10
5. Release the power control and make sure that the
cutting blade stops in less than 10 seconds and
stays stationary.
Blade guard
WARNING: Make sure that the blade guard
is correctly attached before you start the
product. Do not use the product if the blade
guard is missing, defective or has cracks.
The blade guard is installed above the cutting blade.
The blade guard prevents injury if parts of the blade or
pieces from the cut material are thrown in the direction
of the operator.
To examine the blade and the blade guard
WARNING: A damaged cutting blade can
cause injury.
1. Make sure that the cutting blade is attached correctly
and does not show signs of damage.
2. Make sure that the blade guard has no cracks or is
damaged.
3. Replace the blade guard if it is damaged. Refer to
the workshop manual of the product for more
instructions.
Spray guard
The spray guard gives protection from the water that
ejects in direction of the operator. The spray guard also
1461 - 001 - 17.02.2020